TWP 300 Stain 5 Gallon Pail
TWP 300 Series Stain is a high solids, high performance, oil based, exterior wood finish. Its unique formulation enhances the natural beauty and warmth of wood. Special UV absorbing pigments prevent the premature graying, darkening and fading of wood, while carefully selected mildewcides inhibit the growth of mold and mildew on the surface of the finish.
TWP 300 Stain Designed for use on:
- Bamboo Fences
- Outdoor furniture
- Picnic tables
- Playground equipment
- Shutters, doors & windows
Benefits of using TWP® 300 Series:
- Deep gloss or natural stained finish
- Stops UV damage
- Mold and mildew resistant film
- High performance formulation
- Repels water longer
- Furniture like finish
TWP® 300 SERIES is a high performance, high solids, exterior wood finish, which may be applied to obtain a stained or high build, deep gloss finish, depending on application procedures.
TWP® 300 SERIES provides a transparent natural wood tone finish which enhances the natural beauty of the woods grain and color.
TWP® 300 SERIES has superior U.V., waters and abrasion resistance. The finish is also extremely resistant to attack from mildew and wood destroying organisms.
Refer to the Product Data Sheet (PDS) for preparation, cleaning and application instructions. This product is for above ground use only. TWP dealers can find additional product information on the Material Safety Data Sheets (MSDS).
TWP 300 STAIN SURFACE PREPARATION:
NEW WOOD: Sand wood smooth with 150 grit sandpaper or pad to open grain. Rinse surface with 4:1 mix of water and household bleach or wood bleach (best for enhanced color). Rinse thoroughly with water and allow a minimum of 48 hours of good drying conditions before applying TWP.
OLD WOOD: Rinse surface with 3:1 mix of water and household bleach to remove mildew; use wood bleach to brighten wood and follow with 1500 p.s.i. power washer to remove dead surface fiber. Allow a minimum of 48 hours of good drying conditions before applying TWP.
PREVIOUSLY STAINED WOOD: Remove all of the old finish with power washing or paint stripper when necessary. Failure to remove the existing finish will result in a blotchy TWP application due to uneven penetration and discoloration of aged finish.
METHOD OF APPLICATION:
MIX THOROUGHLY BEFORE USING. Apply with brush, roll, spray, wiping cloth or applicator pad. Do not apply below 50° F, if rain is anticipated with 48 hours or heavy dew is present.
DIRECTIONS FOR USE: MIX THOROUGHLY BEFORE USING!
STAINED EFFECT: Apply a thin coat of approximately 400-500 sq.ft/gal. with brush, roll or applicator pad. This should minimize sheen development especially on tight, non-absorbing wood grain. Remove excess or puddled material that has not penetrated after 15 minutes with a paint pad or rags. See special precaution for rag disposal.
GLOSS VARNISH LOOK: Apply a thin coat of approximately 400-500 sq.ft/gal., allow to dry for 48 hours or until firm and then apply a second thin coat.
DRY TIME:
48-96 hours depending on drying conditions. Drying conditions will vary greatly depending on applied film thickness and weather conditions. Multi coat applications may be “tacky” for up to 30 days. Full cure will begin when surface is tack free.
THINNING AND CLEANUP:
No thinning required. Use mineral spirits for equipment clean up.
**Rag Disposal- Lay used rags in a single layer outdoors and allow to air dry for 24 hours. To minimize the chance of spontaneous combustion typical of natural drying oils, place rags in a water filled metal container for disposal.
WARNING:
This product is toxic to fish. Do not contaminate water by cleaning of equipment or disposal of wastes.
